Using the VS-211HDxl
5
5
Using the VS-211HDxl
This section describes how to:
•
Connect the
VS-211HDxl
(see section
5.1
)
•
Select the default master source signal (see section
5.2
)
•
Connect the REMOTE connector (see section
5.3
)
5.1
Connecting the VS-211HDxl 3G HD-SDI Automatic Standby
Switcher
To connect the
VS-211HDxl
, as illustrated in the example in
Figure 2
, do the
following
1
:
1. Connect SDI input source 1 (for example, SDI video camera 1) to the IN 1
BNC connector.
2. Connect SDI input source 2 (for example, SDI video camera 2) to the IN 2
BNC connector.
3. Connect SDI acceptor 1 (for example, SDI display 1) to the OUT 1 BNC
connector.
4. Connect SDI acceptor 2 (for example, SDI display 2) to the OUT 2 BNC
connector.
5. Set the DEFAULT INPUT switch to whichever input is the master input, as
described in section
5.2
.
6. If needed, connect remote switches to the REMOTE IN 1 and IN 2
terminal block connectors, as described in section
5.3
.
7. Connect the 5V DC power adapter to the power socket and connect the
adapter to the mains electricity.
1 Switch OFF the power on each device before connecting it to your VS-211HDxl. After powering up your VS-211HDxl,
switch on the power on each device