KRAMER: SIMPLE CREATIVE TECHNOLOGY
Installing the Audio-Video Matrix Switcher
8
6 Installing the Audio-Video Matrix Switcher
To install the unit, connect the following
1
•
Power cord
to the rear panel, as required:
•
Video input and output cables
•
Audio input and output cables
•
Control Interface cables between switcher units, or PC (or other
controller), as section 6.4 describes
•
Set the dipswitches, as section 6.3 describes
•
Set the system variables using the MENU function, as section 8
describes
Using the unit and/or other 16x16 matrix switchers in the series
2
•
A stand alone switcher (see section
, you can
assemble the following kinds of systems:
6.1)
•
A system of interconnected switchers (see section 6.2)
•
A multi-channel switcher (see section 6.3.3)
6.1 Configuring a Stand Alone Switcher
By default, a single
VS-162AV
unit is configured for:
•
Composite video with 16 inputs and 16 outputs on BNC connectors,
and
•
Balanced stereo audio
3
6.1.1
with 16 inputs and 16 outputs on detachable
terminal block connectors, as section
describes (to configure for
unbalanced
4
6.1.2
stereo audio, see section
)
Configure your
VS-162AV
unit as a stand alone switcher, as Figure 4
illustrates:
1 Switch OFF the power on each device before connecting it to your unit
2 Including the VS-1616SDI (a 16x16 digital video matrix switcher), the VS-1616AD (a 16x16 digital audio matrix switcher),
the VS-1616V (a 16x16 analog video matrix switcher), the VS-1616A (a 16x16 analog balanced stereo audio matrix
switcher), and the VS-162V (a 16x16 video matrix switcher)
3 The VS-162AVRCA (unlike the VS-162AV) is configured for unbalanced stereo audio with 16 inputs and 16 outputs on
RCA connectors
4 However, for an unbalanced stereo audio input, the output will always be half of the input signal. For example, if the input
is 6dB, the output will be 0dB
Summary of Contents for VS-162AV
Page 52: ......
