14
VP-733 - Connecting the VP-733
5.2
Connecting to the VP-733 via RS-232
You can connect to the
VP-733
via an RS-232 connection using, for example, a PC.
Note that a null-modem adapter/connection is not required.
To connect to the
VP-733
via RS-232:
•
Connect the RS-232 9-pin D-sub rear panel port on the
VP-733
unit via a
9-wire straight cable (only pin 2 to pin 2, pin 3 to pin 3, and pin 5 to pin 5 need
to be connected) to the RS-232 9-pin D-sub port on your PC
5.3
Connecting the Balanced/Unbalanced Stereo Audio
Output
Figure 5: Connecting the Balanced
Stereo Audio Output
Figure 6: Connecting an Unbalanced
Stereo Audio Acceptor to the Balanced
Output
5.4
Connecting the VP-733 via the ETHERNET Port
You can connect to the
VP-733
via Ethernet using either of the following methods:
•
Directly to the PC using a crossover cable (see
Section 5.4.1
•
Via a network hub, switch, or router, using a straight-through cable (see
Section 5.4.2
If you want to connect via a router and your IT system is based on IPv6,
speak to your IT department for specific installation instructions.
