10
VP-425 - Controlling the VP-425
5.2.1
The MAIN MENU
Mode
Function
PICTURE
See
Section 5.2.2
ASPECT RATIO
Full, 16:9, 4:3, BEST FIT
OVER SCANNING
Off, 5%, 10%, 15%, 20%
NOISE REDUCTION Off, Min, Typ, Max
OUTPUT
Select the output resolution from the menu (default 720p):
Output resolution: Appears as: Output resolution: Appears as:
480p
480P
SXGA
1280x1024
576p
576P
WXGA
1360x768
720p
720P
1400x1050
1400x1050
1080i
1080I
WSXGA
1440x900
1080p
1080P
UXGA
1600x1200
VGA
640x480
1680x1050
1680x1050
SVGA
800x600
WUXGA
1920x1200
XGA
1024x768
Native
1280x800
1280x800
NATIVE
- Select NATIVE to select the output resolution from the EDID of
the connected HDMI monitor
REFRESH RATE
Select the output refresh rate: FOLLOW, 50Hz, 60Hz
HD OUTPUT COLOR Select the HD output colorspace: RGB, YPbPr
OSD SETTINGS
Set the OSD parameters: H Position, V Position, Transparency,
Timeout and Display (see
Section 5.2.3
)
ADVANCED
AUTO SYNC-OFF
- Turn the auto sync ON/OFF. When ON, this
deactivates the output after a few minutes if no input is present, until
a valid input is again detected or any button is pressed.
This is useful, for example, when the output is connected to a projector,
and the projector will automatically shut down when it has no input
H OFFSET
– adjust the picture H position
V OFFSET
– adjust the picture V position
FREEZE
– set the function of the FREEZE button: MUTE,
MUTE ONLY, FREEZE ONLY
FACTORY DEFAULT Resets to the default parameters
If you cannot see the display after factory reset, use the front panel buttons
to set the correct resolution:
To reset to XGA, press the FREEZE (+) and ENTER buttons
simultaneously for about 2 seconds
To reset to 720p press the – and MENU buttons simultaneously for about 2
seconds
INFORMATION
Displays the input and output resolution (via the INFO display) the
SINK connector type and model, the native resolutions and the
software version
EXIT
Select to exit the menu
Summary of Contents for VP-425
Page 2: ......
Page 16: ...VP 425 13...