Kramer VP-23C, User Manual

Page: 21 / 24

18 VP-23C - Kramer Protocol 2000
INSTRUCTION DEFINITION FOR SPECIFIC INSTRUCTION NOTE
# DESCRIPTION INPUT OUTPUT
0 RESET MACHINE 0 0 1
1 SWITCH GROUPS 1-2 1-3* 2
1-4 4*
Set equal to video and audio inputs
to be switched for the relative group
Set equal to group to which
output is to be switched
2 SWITCH AUDIO OUTPUTS TO
MASTER AUDIO OUT
1-4* Set equal to audio output to be
switched to Master Audio out
1 2
5 REQUEST GROUP STATUS 0 1-4 Set equal to the group of
which status is required
3
6 REQUEST STATUS OF
MASTER AUDIO OUTPUT
0 1 3
11 REQUEST BREAKAWAY
SETTING
0 0 3
16 ERROR Don’t care 0 – Invalid instruction
1 – Out of range 4
18 RESET MACHINE 0 0 1
22 SET AUDIO PARAMETER Parameter Value Parameter
Value: 2, 7, 8, 9,
Audio gain: 1 – Audio Master
2 –Microphone Audio gain: 0-127
Mix microphone: 0 Mix microphone: 0 – mix OFF
1 – Mix ON
24 INCREASE/DECREASE
AUDIO PARAMETER
1 – audio master
2 – microphone 0 - increase output
1 - decrease output 8
25 REQUEST AUDIO
PARAMETER
Equal to input / output number
whose parameter is requested
1 – audio master
2 – microphone
0 9
30 LOCK FRONT PANEL 0 – Panel unlocked
1 – Panel locked 0 2
31 REQUEST WHETHER PANEL
IS LOCKED
0 0 3
42 AUDIO PARAMETER
SETTINGS FOR
INSTRUCTIONS 22, 25
0 0 - Gain
4 - Mix mode 9
57 SET AUTO SAVE 1 – Autosave
2 – No save 5
61 IDENTIFY MACHINE 1 or 2 – Machine name
3 or 4 – Program version 0 – request first 4 digits
1 – request first suffix
10 – request first prefix 6
62 DEFINE MACHINE 1 – Number of inputs
2 – Number of outputs 1 – For video
2 – For audio 3
* 1 – for CV group, 2 – for SV group, 3 – for Comp video group, 4 – for VGA group
NOTE 1
When the master switcher is reset, (e.g. when it is turned on), the reset code is sent to the PC. If this code is sent to the
switchers, it will reset according to the present power-down settings.
NOTE 2
These are bi-directional definitions. That is, if the switcher receives the code, it will perform the instruction; and if the
instruction is performed (due to a keystroke operation on the front panel), then these codes are sent. For example, if:
0000 0001
Instruction “Switch Groups”
1000 0010 Input #2
1000 0001 in composite video group
1000 0001 Machine #1 (master)
Was sent from the PC, then the switcher (machine #1) will switch input 2 in composite video group to its output. If the
user switched input 4 in the VGA group via the front panel keypad, then the switcher will send:
0100 0001
1000 0100
1000 0100
1000 0001 to the PC.
When the PC sends instruction #1 or #2 to the switcher, then, if the instruction is valid, the switcher replies by sending
the same four bytes to the PC that were sent (except for the first byte, where the DESTINATION bit is set high).