Kramer Electronics Ltd.
VP-440
– Operating the VP-440
17
Talkover Mode
Figure 9: Talkover Mode
Operating via Ethernet
You can connect to the
VP-440
via Ethernet using either of the following methods:
•
Directly to the PC using a crossover cable (see
Connecting the Ethernet Port Directly to
).
•
Via a network hub, switch, or router, using a straight-through cable (see
Ethernet Port Directly to a PC
).
If you want to connect via a router and your IT system is based on IPv6, speak to your IT
department for specific installation instructions.
Connecting the Ethernet Port Directly to a PC
You can connect the Ethernet port of the
VP-440
directly to the Ethernet port on your PC
using a crossover cable with RJ-45 connectors.
This type of connection is recommended for identifying the
VP-440
with the factory
configured default IP address.
After connecting the
VP-440
to the Ethernet port, configure your PC as follows:
1. Click
Start
>
Control Panel
>
Network and Sharing Center
.
2. Click
Change Adapter Settings
.
