Kramer Electronics Ltd.
VM-2DT - Connecting the VM-2DT
5
Connecting the VM-2DT
Always switch off the power to each device before connecting it to your
VM-2DT
. After
connecting your
VM-2DT
, connect its power and then switch on the power to each device.
To connect the VM-2DT as illustrated in the example in
1. Connect the HDBT input source (for example,
TP-580T
) to the HDBT IN connector
.
2. Connect the two HDBT outputs
to two HDBT receivers (for example, two
TP-580R
devices).
3. Connect the 5V DC power adapter to the power socket
unit and then connect the
adapter to the mains electricity (not shown in
).
The ON LED lights
.
Figure 2: Connecting to the VM-2DT Rear Panel
