Kramer VM-1411, User Manual, Page: 20 / 25

Connecting the Distribution Amplifiers
18
6.3 Connecting the VM-1411 1:10 Video/Audio Distributor
To connect the
VM-1411
, as shown in the example in Figure 7 , do the
following
1
:
1. Connect up to 2 input video sources (for example, composite video players)
to the VIDEO IN A and VIDEO IN B BNC connectors.
2. Connect up to 2 input audio sources (for example, the audio from the
composite video players) to the L and R terminal block connectors
associated with IN A and IN B.
3. Connect the VIDEO OUT 1 to 5 BNC connectors to up to 5 acceptors
2
(for
example, composite video recorders) on channels A and B.
4. Connect the AUDIO OUT 1 to 5 L and R terminal block connectors to up
to 5 acceptors
2
(for example, the audio input on the video recorders) on
channels A and B.
5. If needed, connect the VIDEO LOOP BNC connector for each channel to
an acceptor (for example, a composite video display or another
VM-1411
)
and set the termination pushbutton to 75

for each connected channel. Set
AC or DC coupling as needed.
6. Connect the power cord
3
to the unit (not shown in the illustration) and then
to the mains electricity. Switch on the power.
7. If needed, adjust the VIDEO GAIN or EQ controls or the AUDIO GAIN on
the front panel.
8. Set the mode of operation by pressing one of the operating mode control
switches as follows:

Press the 2x1:5/1:10 switch to split input "A" to all 10 outputs

Release the 2x1:5/1:10 switch to split inputs "A" and "B" to
outputs sets "A" and "B" respectively.
1 Switch OFF the power on each device before connecting it to your VM-1411. After connecting, switch on the VM-1411
power and then switch on the power on each device
2 You are not required to connect all the acceptors
3 Use the power cord supplied with the unit