Connecting the VM-100CA
7
6 Connecting the VM-100CA
This section defines how to connect the
VM-100CA
. In particular, how to
connect:
A single unit (
1:10 Video Component / Audio Distributor
), see section 6.1
Several
units, see section 6.2
6.1 Connecting a Single VM-100CA Unit
To connect a single
VM-100CA
unit (
1:10 Video Component / Audio
Distributor
) as the example in Figure 4 illustrates, do the following
1
:
1. Connect a component video source (for example, an HDTV satellite
receiver) to the COMPONENT VIDEO INPUT RCA connectors, and to
the S/PDIF INPUT RCA connector.
2. Connect
2
the:
COMPONENT VIDEO OUT 1 RCA connectors to a plasma display, and
the S/PDIF OUT 1 RCA connector to an AV-Receiver
COMPONENT VIDEO OUT 10 RCA connectors, and the S/PDIF OUT
10 RCA connector to a home theater system
3. Leave the LOOP RCA connectors unconnected, and push in the Input
Term buttons to 75 .
Note: if a loop connection is required, for example, to a local monitor,
plug it into the COMPONENT VIDEO LOOP RCA connectors and
release the Input Term button to Hi-Z.
4. Connect the power cord (not illustrated in Figure 4).
5. If required, adjust
3
the Y, B-Y, and R-Y output signal level and/or the Y,
B-Y, and R-Y cable compensation equalization level.
1 Switch OFF the power on each device before connecting it to your VM-100CA After connecting your VM-100CA, switch
on its power and then switch on the power on each device
2 You can connect up to 10 component video output connectors to up to 10 component video acceptors. When less than 10
outputs are required, connect only those outputs of the VM-100CA that are required, and leave the other outputs unconnected
3 Insert a screwdriver into the small hole and carefully rotate it, trimming the OUTPUT level or EQ level
