Using the VA-256P Digital Audio Delay
7
5.3 Setting the Delay Time
Set the delay time via the and + buttons
1
on the front side-panel. The delay
time is displayed (in msec) on the 7-segment display located next to these
buttons.
The maximum delay time is determined by the input sampling rate, as
described in Table 2:
Table 2: Delay Time Settings According to Sampling Rate
Sampling Rate
[kHz]
Delay Time Range
[msec]
32
0 – 4096
44.1
0 – 2960
48
0 – 2720
96
0 – 1360
The delay time setting (per channel) is saved in the non-volatile memory.
5.4 Setting the Display Brightness (Dimmer Setting) Level
Use the dimmer settings to modify the brightness of the two input buttons and
the display.
To set the brightness (dimmer setting) level, do the following:
1. Press both the + and buttons continuously for 3 seconds.
The two input buttons and the + and – buttons illuminate.
The 7-segment display shows the brightness level
2
.
2. Press the + or button to increase or decrease the brightness level.
The brightness of the four buttons and the display is adjusted accordingly.
3. After setting the brightness, exit the dimmer setting by either:
Pressing one of the two input buttons. This input is then selected and
the unit returns to normal operation;
OR by
Waiting 20 seconds
The unit returns to normal operation
The dimmer setting is saved in the non-volatile memory.
1 In 1msec steps
2 Ranging from 1 to 100
