Kramer TP-752R, User Manual

Page: 6 / 14

Kramer Electronics Ltd.
TP-752T / TP-752R – Defining the 2-Wire Extra Range HD Transmitter 4
Defining the 2-Wire Extra Range
HD Transmitter
This section defines TP-752T .
Figure 1: TP-752T 2-Wire Extra Range HD Transmitter
# Feature Function
RESET Recessed Button
Press to reset the device.
BAUD RATE DIP-switches
Set the RS-232 baud rate (baud rate on TP-752T and TP-752R
should be identical), see Setting the Baud Rate on page 9 .
ON LED
Lights green when the device is powered.
Ring Tongue Terminal Grounding
Screw
Connect to grounding wire (optional), see Grounding the TP-
752T/TP-752R on page 8 .
LOOP OUT HDMI Connector
Connect to a local monitor.
HDMI IN Connector
Connect to an HDMI source.
TO TP-752R
(Connect via
one of these
options)
CAT 5/6 RJ-45 Port Connect to the RJ-45 port on TP-752R .
HD15 15-pin HD
Connector
Connect to the 15-pin HD connector on
TP-752R
.
A, B 2-pin
TERMINAL BLOCK
Connector
Connect to the 2-pin terminal block connectors on TP-752R .
For 2-wire cabling where the 2 wires have similar
characteristics (e.g. twin-flex cable), wire by connecting to
the 2 terminals of the terminal block connector.
When using co-ax cable, it is best to wire with the inner
cable connected to the A terminal, and the shield
connected to the ground tab (the ring tongue terminal
grounding screw).
RS-232 9-pin D-sub Connector
Bi-directional RS-232 between the devices, allowing control of the
display from the source end/control of a source from the display
end.
5V DC
+5V DC connector for powering the unit.