Overview
3
3 Overview
The
TP-202
is a twisted pair branching receiver for computer graphics
video signals with resolutions from VGA up to UXGA and higher or HDTV
signals. It takes a twisted pair signal and converts it into a computer
graphics video signal or HDTV signal available on two 15-pin HD outputs,
and simultaneously re-transmits the original twisted pair signal to another
compatible receiver.
The
TP-202
UXGA Line Transceiver/DA
:
•
Has a transmission range of more than 300ft. (more than 100 meters)
•
Can receive HD signals (high-definition resolutions: 480p, 576p, 720p,
1080i and 1080p)
•
Includes two XGA outputs on 15-pin HD connectors
•
Includes EQ. and LEVEL controls
•
Can change the polarity of decoding H and V Sync for UXGA graphics
•
Is 12V DC fed and can power or be powered by the receiver over the
same CAT 5 cable (see section
3.1
)
•
Features a CAT 5 output for transmitting the signal to an additional
receiver
3.1
About the Power Connect Feature
The Power Connect feature applies as long as the cable can carry power.
This feature is available when using STP cable and the distance does not
exceed 50m on standard CAT 5 cable. For longer distances, heavy gauge
cable should be used
1
.
For units which are connected via RJ-45 connectors,
make sure that the shield of the STP cable is connected to the metal casing
of the connectors on both ends of the cable. For units which are connected
via terminal block connectors, the shield of the STP cable must be
connected to a ground terminal on the units at both ends (use the ground
terminal of the power supply connection if necessary).
For a CAT 5 cable exceeding a distance of 50m, separate power supplies
should be connected to the transmitter and to the receiver simultaneously.
1 CAT 5 cable is still suitable for the video/audio transmission, but not for feeding the power at these distances
