Kramer TP-100AXR, User Manual

Page: 10 / 16

KRAMER: SIMPLE CREATIVE TECHNOLOGY
Connecting the PC/Audio Line Transmitter/Receiver
8
5 Connecting the PC/Audio Line Transmitter/Receiver
You can use the TP-100AXR and TP-200AXR to configure a PC/Audio Line-
to-Twisted Pair Transmitter and Receiver system.
• To connect a transmitter/ receiver pair, see section 5.1
• To connect multiple devices, see section 5.2
5.1 Connecting a Transmitter/Receiver Pair
To connect the TP-100AXR PC/Audio Line Transmitter with the
TP-200AXR PC/Audio Line Receiver , as the example in Figure 3
illustrates, do the following
1
1. On the
TP-100AXR
, connect a PC source (for example, a laptop’s graphics
card) to the PC INPUT 15-pin HD (F) connector and the PC audio source
:
2
to the AUDIO IN 3.5mm mini jack3
2. On the TP-200AXR , connect the PC OUT 15-pin HD (F) connector to the
PC acceptor (for example, a display), and connect the AUDIO OUT S/PDIF
RCA connector to the digital audio acceptor (for example, an AV Receiver),
and the ANALOG 3.5mm mini jack to the analog audio acceptor (for
example, a stereo audio recorder).
.
3. Connect the LINE OUTPUT RJ-45 connector on the
TP-100AXR
to the
LINE IN RJ-45 connector on the TP-200AXR , via UTP cabling (the range
can exceed 300ft (>100m)), see section 5.3 .
4. Connect the 12V DC power adapters to the power sockets
4
and connect the
adapters to the mains electricity on both
5
5. On the
TP-200AXR,
adjust
the TP-100AXR and the
TP-200AXR
.
The signal from the PC source is transmitted via CAT 5 cable, decoded and
converted at the PC OUT 15-pin HD (F) connector to the PC acceptor.
6
the video output signal level and/or cable
compensation equalization level and make sure the termination pushbuttons
are pressed IN.
1 Switch OFF the power on each device before connecting it to your Kramer product. After connecting your product
,
switch
on its power and then switch on the power on each device
2 Any audio source can be used. It does not have to come from the PC
3 Using, for example, a Kramer C-GMA/GMA cable (VGA 15-pin HDM +audio jack to VGA 15-pin HDM +audio jack).
Not supplied. The complete list of Kramer cables is on our Web site
4 Switch OFF the power on each device before connecting it to your Kramer product. After connecting your
product , switch
on its power and then switch on the power on each device
5 Alternatively, you can connect the power to one unit only
6 Use a screwdriver to carefully rotate the trimmer, adjusting the appropriate level