810B - Connecting and Adjusting the 810B
5
4
Connecting and Adjusting the 810B
Always switch off the power to each device before connecting it to your
810B
. After connecting your
810B
, connect its power and then switch
on the power to each device.
To connect the
810B
as illustrated in the example in
Figure 2
:
1. Connect the composite video BNC OUT 1 connector to the composite
acceptor (for example, a non-linear editor).
2. Connect the composite video BNC OUT 2 connector to the composite
acceptor (for example, a genlockable camera).
3. Connect the s-Video (Y/C) 4-pin Y/C OUT connector to the s-Video (Y/C)
acceptor (for example, an AV diagnostic switcher).
4. Connect the 3-wire cable to the detachable terminal block 1kHz OUT
connector and to the audio input of the destination unit (for example, the AV
diagnostic switcher).
5. Connect the 12V DC power adapter to the power socket and connect the
adapter to the mains electricity (not shown in
Figure 2
).
Figure 2: Connecting the 810B
Black Burst/Audio Generator
i
Summary of Contents for TOOLS 810B
Page 2: ......
