10
TBUS-201 - Installing the TBUS-201
5. Connect the IEC power cord to the IEC socket.
6. Insert the power cord into the power connector lock and tighten the screw
(see
Figure 2
, item 12) to secure the power cable.
5.3
Inserting the TBUS-201 through the Cut-Out Opening
To install the
TBUS-201
, do the following:
1. Carefully insert the unit into the prepared opening.
2. Take the support brackets under the table and place them into the support
bracket grooves at the desired height (on both the front and rear sides of the
unit).
3. Make sure that the upper outer rim is situated parallel to the edge of the
table.
4. Insert the table securing screw through the holes in the support brackets and
tighten them until they reach the table surface (from underneath).
5.4
Connecting the Cables
1. Connect the appropriate cables from underneath.
2. Secure the cables.
Do not keep the cord too tight or too loose.
Once you have connected the unit to the mains power and connected the proper
cables, you may use the unit.
