Mounting the TA-110HD
5
5 Mounting the TA-110HD
To
mount the
TA-110HD
in the Power Tower, do the following:
1. Remove the three base screws from the underside of the Power Tower,
and open the base cover (saving the screws).
2. Slide out the blank panel and any modules/panels.
3. Connect the
TA-110HD
(see section 6) and then slide the
TA-110HD
into place.
4. Replace the other modules/panels and the blank panel.
5. Replace the base cover and fasten the three base screws back in place.
6 Using the XGA Line Transmitter(s) / Receiver
You can use the
TA-110HD
XGA Line Transmitter
and the
TP-120
XGA Line
Receiver
to configure an XGA-to-Twisted Pair Transmitter and Receiver system.
To
connect the
TA-110HD
XGA Line Transmitter
with the
TP-120
XGA Line
Receiver
, as the example in Figure 2 illustrates, do the following:
1. On the
TA-110HD
, connect the XGA source (for example, the HD-15
output from a computer’s graphics card) to the XGA IN HD15F
connector.
2. On the
TP-120
, connect the XGA OUT HD15F connector to the XGA
acceptor (for example, a monitor).
3. Connect the LINE OUT RJ-45 connector on the
TA-110HD
to the
LINE
IN RJ-45 connector on the
TP-120
, via UTP cabling (transmission can
exceed 300ft (>100m)).
4. On both
1
the
TA-110HD
and the
TP-120
, connect the 12V DC power
adapter to the power socket and connect the adapter to the mains
electricity.
The signal from the XGA source is transmitted via CAT 5 cable,
decoded and converted at the XGA OUT HD15F connector to the XGA
acceptor.
5. On the
TP-120
, adjust
2
the output signal level and/or cable compensation
equalization level, if required.
6. If necessary, set the HS and VS switches
3
, on the units.
1 For distances of up to 50 meters you can connect a power adapter to either the TA-110HD or TP-120. Above it, both sides
should be fed with power
2 Use a screwdriver to carefully rotate the trimmer, adjusting the appropriate level
3 By default, both switches are set for normal H SYNC and V SYNC polarity
