6
SPK-W511T - Installing the SPK-W511T
4
Installing the SPK-W511T
This section explains how to:
•
Choose the best location for your speakers (see
Section 4.1
•
Install the speaker wires (see
)
Section 4.2
•
Install the mounting brackets (see
)
Section 4.3
•
Setup an array installation (see
)
Section 4.4
•
Install the
SPK-W511T
(see
)
Section 4.5
4.1
Choosing the Best Location
)
Before installing the speakers:
•
Experiment by placing the speakers in different locations before finally
deciding on the most suitable location
•
Be sure that the wall type is appropriate for the mounting brackets, that is,
either solid wood, bricks, concrete, hollow building blocks, or wood studs
•
Check that the mounting location is free of obstructions, such as electrical
piping, AC ducts or water lines, and so on
4.2
Installing the Speaker Wires
To install the speakers, do the following:
1. Prepare the wires for the speakers:
Cut the wires to similar lengths
For achieving high quality sound
Measure the length from each speaker to the receiver, and cut the
wires accordingly, adding some access wire length to let you easily
remove the speakers from the bracket without having to disconnect the
input wires
The distance should measure up to about 4 meters (13 feet)
2. Strip the ends of the wires to expose a length of approximately 3/8 inch.
im Vertrieb von CAMBOARD Electronics
www.camboard.de
Tel. 07131 911201
Fax 07131 911203
