KRAMER: SIMPLE CREATIVE TECHNOLOGY
Installing the Closed-back Ceiling Speakers
8
11. If required, you can further secure the speaker by connecting the speaker
support ring to an independent secure anchor point.
12. Adjust each speaker to the appropriate tap setting
1
before installing the
grille
2
(see Figure 6).
Figure 6: Adjust Tap Selector (for the SPK-CC688)
13. Install the grilles to the speakers:
Push the grille fastener into the hole in front of the baffle
Press the grille into place until the front of the grille is flush with the
rim of the baffle
Check that the grille is securely seated
3
5.3 Painting the Speaker
You can paint the speakers before or after the speaker is installed.
When painting before installation:
Clean the rim and grille with mineral spirits or other light solvent that is
unlikely to damage the surface
Spray with color by holding the spray can at an angle of 45
Note
: When spraying the grille, take care not to clog the holes in the grille
as this will greatly reduce the sound quality of the speakers
1 The tap selector has different values depending on the model. For example, Figure 6 shows the Tap Selector for the
SPK-CC688
2 In addition to the 8 setting, the power taps are 30W, 15W, 7.5W and 3.7W at both 70.7V and 100V, with a 1.8W tap for
70.7V only
3 To remove the grille, insert two bent paper clips into the holes in the grille and carefully pull it down. Repeat this around the
perimeter of the grille until it is completely removed
