![background image](http://html.mh-extra.com/html/kramer/rc-11tb/rc-11tb_user-manual_2002170001.webp)
The Kramer RC-11TB 1-Button Contact Closure Switch
Congratulations on purchasing your Kramer
RC-11TB
single slot wall plate insert
1-Button
Contact Closure Switch
which is ideal for using as a means of remote control in boardrooms
and conference rooms. It can be used with the
SID-X1
step−in commander or any other
Kramer product with contact closure control.
The
RC-11TB
front panel has one momentary switching button. On the rear are remote
momentary contact closure terminal block connectors that connect to a remote switch terminal
block connector.
Figure 1
shows the
RC-11TB
front panel and the pinout on the rear:
Figure 1: RC-11TB Front Panel and Rear
To install the front panel button label:
1. Unscrew the two spacers, remove the washers on the rear side of the insert and push
out the two studs holding the front panel, see
Figure 2
.
Figure 2: Removing the Front Panel
2. Separate the PC board from the front panel.
3. Remove the required label from the supplied button label sheet.
4. Hold the button cap so that it is oriented as shown in
Figure 3
, with the “wings” at the top
and lower sides.
Figure 3: Button Orientation
5. Insert the label (properly oriented) inside the cap.
6. Retaining the orientation, place the button cap with the label over the buttons, see
Figure 4
.
Figure 4: Placing the Button Cap
7. Place the front plate over the button.
8. Reassemble the PC board
Note
: Center the button in the opening before tightening the spacers to prevent the button
from sticking during reassembly.
9. Place the washers and then the spacers and tighten.
O N