PT-871xr
Quick Start
P/N: 2 9 0 0 - 3 0 1 2 3 4 QS
Rev: 1
Scan for full manual
PT-871xr Quick Start Guide
This guide helps you install and use your
PT-871xr
for the first time.
www.kramerav.com/downloads/PT-871xr
to download the latest user manual and check if firmware
upgrades are available.
Step 1:
Check what’s in the box
PT-871xr
HDMI 4K Line Transmitter
4 Rubber feet
1 Bracket set
1 Power adapter and cord
1 Quick start guide
IMPORTANT NOTICE!
We highly recommend using only Kramer UNIKAT cables with these products. If using 3
rd
party shielded CAT-6A cables, both ends of the
shield must be soldered to the connectors for the products to function properly. Do not use any jumpers, unshielded wall plates or mid-
span cable connections. These extenders are not compatible with HDBaseT technologies. Prior to signal extension, ensure that the
extension line cable is lying straight and not coiled.
Step 2: Get to know your PT-871xr
The terms HDMI, HDMI High-Definition Multimedia Interface, and the HDMI Logo are trademarks or registered trademarks of HDMI Licensing Administrator, Inc.
#
Feature
Function
1
LED Indicators
IN
Lights when an active source is connected to HDMI IN.
2
OUT
Lights when an active acceptor is connected to HDMI OUT on the receiver (for example,
WP-872xr
).
3
ON
Lights when power is connected to the device.
4
HDMI
™ IN Connector
Connect to an HDMI source.
5
SETUP DIP-switches
Set the operation DIP-switches. Both DIP-switches are set to OFF (up) by default.
Always set the DIP-switches identically on transmitter and receiver devices.
DIP-switch 1:
Compression Options
OFF (up)
– Standard compression level.
ON (down)
– High compression level for additional range extension.
DIP-switch 2:
Compression Setup
OFF (up)
– Enable compression (mandatory).
ON (down)
– For future use.
6
DGKat-2.0 OUT RJ-45 Connector
Connect to the DGKat-2.0 IN connector on the receiver (for example,
WP-872xr
) using twisted
pair cable.
7
12V DC Connector
Connect the power adapter to one of the devices.
Step 3: Install the PT-871xr
Install
PT-871xr
using one of the following methods:
•
Attach the rubber feet and place the unit on a flat surface.
•
Fasten a bracket (included) on each side of the unit and attach it to a flat surface
www.kramerav.com/downloads/PT-871xr
•
Mount the unit in a rack using the recommended rack adapter
www.kramerav.com/product/PT-871xr
•
Ensure that the environment (e.g., maximum ambient temperature &
air flow) is compatible for the device.
•
Avoid uneven mechanical loading.
•
Appropriate consideration of equipment nameplate ratings should be
used for avoiding overloading of the circuits.
•
Reliable earthing of rack-mounted equipment should be maintained.
