Kramer MODULAR TBUS-1Axl, User Manual

Page: 20 / 27

16 TBUS-1Axl - Installing the TBUS-1Axl
5.4 Inserting the TBUS-1Axl
t
hrough the Cut Out Opening
To install TBUS-1Axl in the opening:
1. Remove the protective rubber guard from around the outer rim of the
TBUS-1Axl housing. Beware of the sharp edge!
2. Carefully insert the unit into the prepared opening (see Figure 9 ).
3. Take the support brackets under the table and place them into the support
bracket grooves on both sides of the unit (see Figure 2 , item 7).
4. Verify proper alignment of the unit before tightening the mounting screws.
5. Tighten both mounting butterfly screws upward until they reach the table
surface (from underneath). Tighten firmly (see Figure 9 ).
6. Tighten the locking butterfly screws downward until tight against the
mounting bracket.
Figure 9: Inserting TBUS-1Axl into the Prepared Opening
5.5 Connecting the Cables
When replacing blank inserts with connector inserts (for example, VGA, audio,
HDMI and so on):
1. Insert the cables to their appropriate connectors from underneath.