Kramer Electronics Ltd.
KWC-1
– Installing KWC-1
5
Installing KWC-1
To install
KWC-1
:
1. Cut an opening in the table (see
2. Insert the unit
through the opening and secure it to the table (see
Drilling a Hole in the Table
To drill an opening in the table
:
1. Using any standard hole saw drill bit with a diameter ranging from 106mm to 108mm
(4.17in to 4.25in), drill a hole in the table in the desired location.
The thickness of the table should be 3in (76mm) or less.
2. Clean the table surface.
Take care not to damage the table. Kramer Electronics is not responsible for any damage
caused to the table.
Mounting KWC-1 in the Table
To mount the unit:
1. Insert
KWC-1
into the hole cut in the table
making sure that the outer rim sits firmly
against the surface of the table.
2. Fit the screw into the mounting bracket (a).
3. From underneath the table, insert/slide the
screw into the appropriate hole in
KWC-1
.
Tighten the mounting screw butterfly (b)
upward against the table.
4. Lock the mounting screw into position with
the locking butterfly screw (c).