Step 3: Mounting the KT-107SC / KT-107SCRB
Mounting on the wall:
Before mounting
KT-107SC
on a wall, install an in-wall junction box (recommended boxes are listed in the user manual)
1. Attach the on-wall mount unit to the installed junction box (top side up see indication arrows on unit).
Connect Ethernet and/or power cables and optionally, insert the right-angle USB cable (supplied) for connecting to an
adjacent external USB device.
2. Screw the 4 wall-mounting screws (supplied) through the screw openings.
The various screw openings fit various types of wall junction boxes.
3. On the rear side of the
KT-107SC
, remove the screw cover and the
cover (by slightly pressing downwards and then pulling out) and set
aside.
4. Attach the panel mount plate to the rear side of the
KT-107SC
(using 4 M2x4 screws, supplied).
5. Connect the flat cable from the on-wall mount (attached to the in-
wall junction box) to the connector on the rear of
KT-107SC
.
6. Hang the
KT-107SC
on the wall by sliding the tabs on the attached
panel mount plate over the grooves on the on-wall mount unit.
For optimum range and performance use the recommended Kramer cables
available at
www.kramerav.com/product/KT-107SC
Using third-party cables may cause damage!
Step 4: Connect the power
Connect the power cord to
KT-107SC
and plug it into the mains electricity.
Safety Instructions (See
for updated safety information)
Caution:
•
There are no operator serviceable parts inside the unit.
Warning:
•
Use only the power cord that is supplied with the unit.
•
Disconnect the power and unplug the unit from the wall before installing.
Step 5: Customizing the KT-107SC / KT-107SCRB settings
The Settings page is accessible from the Home-page and enables customizing the
KT-107SC
settings:
