#
Feature
Function
11
AUDIO 3.5mm Jack
Encoder mode: Connect to an unbalanced analog audio source for embedding
audio in the streaming signal.
Decoder mode: Connect to an unbalanced analog audio acceptor for
de-embedding audio from the streaming signal.
12
IR OUT 3.5mm Jack
Connect to a 38kHz IR transmitter for transmitting the IR signal that was extended
via the streaming line. For example, connect to an IR transmitter to control a
display.
13
IR IN 3.5mm Jack
Connect to a 38kHz IR sensor for extending the IR signal via the streaming line.
14
RS-232 3-Pin Terminal Block
Connect to a serial controller or serial controlled device for extending the serial
control signal via the streaming line to control an external device.
15
SERVICE Mini USB Connector
For internal use.
16
1GbE LAN RJ-45 Connector
Connect to a 1G device.
17
12V DC Connector
Connect to the power adapter.
The terms HDMI, HDMI High-Definition Multimedia Interface, and the HDMI Logo are trademarks or registered trademarks of HDMI Licensing Administrator, Inc.
Step 3: Install the KDS-8
Mount to a flat surface using the attached mounting brackets or place on a flat surface.
Step 4: Connect the inputs and outputs
Always switch OFF the power on each device before connecting it to your
KDS-8
. For best results, we recommend that you
always use Kramer high-performance cables to connect AV equipment to the
KDS-8
.
Step 5: Connect the power
Connect to a 10G Ethernet switch that provides PoE (Power over Ethernet) or connect the power cord to
KDS-8
and plug it
into the mains electricity.
Safety Instructions
Caution:
There are no operator serviceable parts inside the unit.
Warning:
Use only the power cord that is supplied with the unit.
Warning:
Do not open the unit. High voltages can cause electrical shock! Servicing by qualified personnel only.
Warning:
Disconnect the power and unplug the unit from the wall before installing.
for updated safety information
Step 6: Operate the KDS-8
Change the encoder / decoder mode:
The unit is defined as an encoder by default.
•
Press and hold the + (plus) and – (minus) buttons simultaneously for 10 seconds.
The encoder / decoder mode changes.
Stream Video:
1. Connect a unit in encoder mode and a unit in decoder mode to the same 10G Ethernet switch.
KDS-8
is plug-and-play
with DHCP enabled.
2. Subscribe the decoder to the encoder source using Kramer Network Enterprise Management Platform (go to
www.kramerav.com/product/Kramer Network
Tx Rx G
AUDIO
IR OUT
IR IN
RS-232
SERVICE
1GbE LAN
10GbE (PoE)
HDMI OUT
HDMI IN
TM
TM
HDMI
Media Player
Audio
Amplifier
Audio Source
HDMI
4K Display
IR Controller
IR
Eth
Tx Rx G
AUDIO
IR OUT
IR IN
RS-232
SERVICE
1GbE LAN
10GbE (PoE)
HDMI OUT
HDMI IN
TM
TM
Display
Audio
4K Display
HDMI
1G Device
IR
RS-232
RS-232
Serial
Controller
Eth
KDS-8 as encoder
KDS-8 as decoder
10Gbit/s LAN
1G Device
Eth
