K-POD302
Quick Start (P/N: 2900-301100QS REV 3)
P/N:
2 9 0 0 - 3 0 1 1 0 0 QS
Rev:
3
Scan for full manual
K-POD302 Quick Start Guide
This guide helps you install and use your
K-POD302
for the first time.
http://www.kramerav.com/downloads/K-POD302
to download the latest user manual and check if
firmware upgrades are available.
Step 1: Check
what’s in the box
K-POD302
Mounting Enclosure for Kramer 3−Gang Size Products
4 M3X8 screws
2 4x1/2" screws
1 Quick start guide
Step 2: Get to know your K-POD302
#
Feature
Function
1
Mounting Frame
For mounting
Kramer 3−gang size device.
2
Table Screw Openings (x2)
For attaching the
K-POD302
onto the surface.
3
Cable Opening
Use to pass the cables either through the rear side of
K-POD302
or under the
table/podium (if the surface has a cut-out opening).
4
Device Mounting Screw Openings (x4)
For attaching the
Kramer 3−gang size device to the
K-POD302
.
Step 3: Mount the K-POD302 onto a surface
If you plan to pass the cables under the table you need to drill a hole in the table before mounting
K-POD302
onto the surface.
If you plan to pass the cables through the rear opening, skip the first part in this section.
To drill a hole in the table:
1. Place the
K-POD302
on the surface
and carefully mark the opening area
so it fits the opening in the
K-
POD302
.
2. Using any standard cup bit drill, with a
diameter of 30mm (1.2”), drill a hole in the
table in the desired location.
3. Clean the table surface.
Take care not to damage the table.
Kramer Electronics is not responsible
for any damage caused to the table.
