K-CONFIG –
Adding Actions to a Trigger
133
9.2
Adding a Port Command
To add actions to a trigger (for example, to the built-in All On trigger)
:
1.
In the
Triggers
area, select the
All On trigger
.
2.
In the Action Editor, select the Port Command and select the desired port.
A specific driver was assigned to the selected port, therefore it is selected automatically
Figure 253: Selecting the Port Command Action Type
3.
Select the Command (for example, PWR_ON):
Note that PWR_ON is a shared command, previously defined in the Driver Manager (see
Section 5
).
Figure 254: Selecting the Command