116
K-CONFIG - Using the Triggers
Figure 214: Adding a Monitor Event to the Available Triggers List
You can edit the trigger to respond to a different command by selecting that command and then clicking the
button.
3.
Add actions to the trigger (see
Section 9
8.4
GPI/O Events Triggers
The GPI/O (General Purpose Input/Output) port can be configured via the
K-CONFIG
software. Using GPI/O, you can
select a wide range of events that can trigger a series of actions, for example, when an alarm is set or if the room
temperature exceeds a certain value.
Only GPI/O ports on the master room controller can be used in the Room Control setup (
SL-12
is the master room
controller in this example). The GPI/O ports are set in the port manager as follows:
Figure 215: GPI/O Events – Port Manager Setup
Digital output acts in the same way as do relays so it cannot be used as a trigger (see
Section 9.3
).
Once the master room controller is set, the GPI/O Events appears in the
Project Navigator
:
Figure 216: GPI/O Events – GPI/O in Project Navigator
To create a GPI/O event
:
1.
Select
GPI/O Events
and click
+
to create a new GPI/O trigger. The following window appears:
