Kramer FC-7P, User Manual, Page: 8 / 58

Kramer Electronics Ltd.
FC-7P
– Performing Initial Configuration
6
Performing Initial Configuration
This chapter provides an overview of the initial configuration and basic operation of the FC-7P
and comprises:
•
Configuring the FC-7P (see Configuring FC-7P
Ethernet Gateway −
GPIO/Relay on page 6 )
•
Configuring an Ethernet connection on the PC (see Setting Up an Ethernet Connection
on the PC on page 7 )
Figure 3: Connecting the FC-7P for Initial Configuration
Configuring FC-7P Ethernet Gateway − GPIO/Relay
The FC-7P is shipped from the factory with DHCP enabled (off by default) and a random IP
address. To connect the FC-7P on first installation, you must identify the IP address that was
automatically assigned to the FC-7P . To discover the IP address of FC-7P , use K-LAN
Configurator, available for download from our website at www.kramerav.com .
To browse the FC-7P Web UI on taking the device out of the box:
Use the default host name: FC-7-xxxx , where xxxx are the last four digits of the serial number
of the device .
To configure the FC-7P:
1. Connect the Ethernet port on the rear panel of the FC-7P to a PC, either directly or via a
LAN, (see Connecting via Ethernet on page 10 ).
2. Using a Web browser and the relevant IP address or host name (see Default
Parameters on page 27 ), browse the General Info home page (see Figure 10 ).
3. Click Device Settings to browse to the Device Settings page, (see Figure 11 ).
4. Enter the time and date manually or enter the Time server address for automatic time
and date synchronization.
5. Click Save Changes .