Kramer FC-7, Quick Start Manual, Page: 1 / 2

FC-7 Quick Start (P/N: 2900-300597QS REV 1)
P/N:
2 9 0 0 - 3 0 0 5 9 7 QS
Rev:
1
Scan for full manual
FC-7 Quick Start Guide
This guide helps you install and use your FC-7 for the first time.
Go to www.kramerav.com/downloads/FC-7 to download the latest user manual and check if firmware
upgrades are available.
Step 1: Check w
hat’s in the box
FC-7 Ethernet Gateway
4 Rubber feet 1 Bracket set
1 USB-A to USB mini cable 1 Quick start guide
Step 2: Get to know your FC-7
# Feature Function
1 LAN RJ-45 Connector Connects to an IP client or other controller, either directly or via a LAN
2 Activity LEDs
Ports 1 and 2, white (upper) and
blue (lower) Show the transmission status of port 1 and port 2:
When set as GPIO, the white LED indicates active IO-P1 and blue LED indicates active IO-P2
When set as RELAY, the white LED indicates active Relay-P1 and blue LED indicates active
Relay-P2
3 RESET Button Press and hold while cycling the device power to reset to factory default parameters
4 SERVICE Mini USB Connector Connects to a USB power source for powering and to a PC for a local firmware upgrade
5 ON LED Lights green when the unit is powered on
6 MODE DIP-switches
(Port 1 and Port 2) Switch up (off) for GPIO, switch down (on) for relay
The default setting is port 1 GPIO (up) and port 2 relay (down)
7 Port 1 and 2 I/O 3-pin Terminal
Block Each terminal block port connects to two GPIO ports or one relay
8 5V DC Connector For extra power resiliency, connect to the optional 5V DC power supply, center pin positive.
Not needed when the device is supplied power by a USB power source