Kramer FC-46H2, User Manual, Page: 8 / 15

Kramer Electronics Ltd.
FC-46H2
– Connecting the FC-46H2
6
Connecting the FC-46H2
Always switch off the power to each device before connecting it to your FC-46H2 . After
connecting your FC-46H2 , connect its power and then switch on the power to each device.
Figure 2: Connecting to the FC-46H2 Rear Panel
To connect the FC-46H2 as illustrated in the example in Figure 2:
1. Connect an HDMI source (for example, a Blu-ray player) to the
HDMI™ IN connector
.
2. Connect the HDMI
™ OUT connector
to an HDMI acceptor (for example, a display).
3. Connect the AUDIO OUT:
▪
The ANALOG 5-pin terminal block connector to an analog audio acceptor (for
example, a power amplifier with speakers).
▪
The S/PDIF RCA connector to a digital audio acceptor (for example, a receiver).
4. Connect the MUTE 2-pin terminal block connector to a contact closure switch (for
example, Kramer RC-21TB , not shown in Figure 2 ).
5. Set the SETUP DIP-switches on the front panel (see Setting the DIP-Switches
on page 7 ).
6. Connect the power adapter to the FC-46H2 and to the mains electricity (not shown in
Figure 2 ).
6
7
8
9
8
2