FC-404NETxl
Quick Start
P/N: 2 9 0 0 - 3 0 1 5 3 7 QS
Rev: 2
Scan for full manual
FC-404NETxl Quick Start Guide
This guide helps you install and use your
FC-404NETxl
for the first time.
Go to
www.kramerav.com/downloads/FC-404NETxl
to download the latest user manual and check if
firmware upgrades are available.
Step 1: Check
what’s in the box
FC-404NETxl
4x4 Audio and Dante Mixer
1 Power cord and adapter
1 Quick start guide
1 Bracket set
4 Rubber feet
Step 2: Get to know your FC-404NETxl
#
Feature
Function
1
OUT LEDs (1 to 4)
Lights green when a signal is present, lights red when clipping is detected.
2
IN LEDs (1 to 4)
Lights green when a signal is present, lights red when clipping is detected.
Use the embedded web pages to select line level, mic level or 48V for each input.
3
SYNC LED
Lights green when Dante network is available or red if an error occurred.
4
SYS LED
Lights green for digital audio normal operation.
Flashes green when this unit is the Master clock.
Lights red if an error has occurred.
5
Rx LED
Lights green when an RS-232 signal is received.
6
Tx LED
Lights green when an RS-232 signal is transmitted.
7
HEADPHONES 3.5mm Mini Jack
Connect to a headphone set.
8
ON LED
Lights green when the device is powered.
9
AUDIO INPUTS 3-pin Terminal
block Connectors (1 to 4)
Connect to analog balanced mono line/mic level (with selectable 48V) sources.
10
AUDIO OUTPUTS 3-pin Terminal
block Connectors (1 to 4)
Connect to analog balanced mono line level acceptors.
11
Dante RJ-45 Connector
Connect to Dante audio via the network. Provides 4 Tx channels and 4 Rx channels.
By default, DHCP is enabled.
12
RS-232
3-pin Terminal Block
Connector
Connect to a PC/serial controller.
13
ETHERNET
RJ-45 Connector
Connect to a PC via a LAN.
14
RESET Recessed Button
Reset/reboot the device: press and release the button.
Reset to factory default values: press and hold the button for 30 secs.
15
12V DC Power Connector
12V DC connector for powering the unit.
Step 3: Mount FC-404NETxl
Install
FC-404NETxl
using one of the following methods:
•
Attach the rubber feet and place the unit on a flat surface.
•
Fasten a bracket (included) on each side of the unit and attach it to a flat surface
(see
www.kramerav.com/downloads/FC-404NETxl
•
Mount the unit in a rack using the recommended rack adapter
(see
www.kramerav.com/product/FC-404NETxl
•
Ensure that the environment (e.g., maximum ambient temperature &
air flow) is compatible for the device.
•
Avoid uneven mechanical loading.
•
Appropriate consideration of equipment nameplate ratings should be
used for avoiding overloading of the circuits.
•
Reliable earthing of rack-mounted equipment should be maintained.
•
Maximum mounting height for the device is 2 meters.
