Step 3: Install the FC-174
Install
FC-174
using one of the following methods:
Attach the rubber feet and place the unit on a flat surface.
Fasten a bracket (included) on each side of the unit and attach it to a flat surface.
For more information go to
www.kramerav.com/downloads/FC-174
Mount the unit in a rack using an optional
RK-T2B
rack adapter.
Step 4: Connect the inputs and outputs
Always switch OFF the power on each device before connecting it to your
FC-174
. For best results, we recommend that you always
use Kramer high-performance cables to connect AV equipment to the
FC-174
.
Step 5: Connect the power
Connect the 5V DC power adapter to the power socket and then connect the adapter to the mains electricity.
Safety Instructions
Caution:
There are no operator serviceable parts inside the unit.
Warning:
Use only the Kramer Electronics power supply that is provided with the unit.
Warning:
Disconnect the power and unplug the unit from the wall before installing.
See
for updated safety information.
Step 6: Operate the FC-174
Use the OSD menu to set the parameters:
Menu Item
Function
Channel 1 to Channel 4
Input EDID Select
: Sink User or Internal
4K2K 50/60 RGB
: 4:2:0 Downsampling, 4:2:2 Downsampling or Passthrough.
4K2K 50/60 YUV4:4:4
: 4:2:0 Downsampling, 4:2:2 Downsampling or Passthrough.
4K2K 50/60 YUV4:2:2
: 4:2:0 Downsampling, 4:2:2 Downsampling or Passthrough.
Auto Sync Off
: Disable, Slow or Fast.
Output Pattern
: Mode (On/Off), Timing and Pattern Type.
OSD
: Display Information (Yes/No) and Display Timeout.
Main OSD
Display Select
: All Channels or one Channel (set Main OSD to appear on all channels or on one of
the four channels).
Display Timeout
: 5 to 40 sec, Off
Channel Information
Channel 1 to 4
: Resolution, Input Colorspace, Output Colorspace, Input HDCP, Output HDCP
Firmware Version
System Setting
Firmware Update
.
Factory Reset
.
