34
FC-132ETH - Configuring and Maintaining the FC-132ETH
To activate and deactivate DHCP:
1. Press the DHCP button on the front panel.
DHCP is activated, the DHCP LED lights green and the selection is shown
on the display.
2. Press the DHCP button again.
DHCP is deactivated, the DHCP LED no longer lights and the selection is
shown on the display.
10.4
Resetting to the Factory Default Settings
To reset the device to its factory default settings:
1. Turn off the power to the device.
2. Press and hold the Reset button on the front panel.
3. Turn on the power to the device while holding down the Reset button for a
few seconds.
4. Release the button.
The device is reset to the factory default settings.
10.5
Upgrading the Firmware
For instructions on upgrading the firmware see the “
Kramer K-Upload User
Manual
”.