FC-101NET Quick Start (P/N: 2900-300861QS REV 1)
P/N:
2 9 0 0 - 3 0 0 8 6 1 QS
Rev:
1
Scan for full manual
FC-101NET Quick Start Guide
This guide helps you install and use your
FC-101NET
for the first time.
www.kramerav.com/downloads/FC-101NET
to download the latest user manual and check if
firmware upgrades are available.
Step 1: Check w
hat’s in the box
FC-101NET
Dual Dante Interface
1 Bracket set
Double-sided adhesive dual lock tape
1 Quick start guide
Step 2: Get to know your FC-101NET
#
Feature
Function
1
ON LED
Lights green when the device receives power.
2
SYS LED
Lights green when Dante network is available; red if an error has occurred.
3
SYNC LED
Lights green for digital audio normal operation; red if an error has occurred.
4
Dante PoE RJ-45 Port
Connect to the Dante audio source via the Network and provide Power over Ethernet
(PoE) to the device.
By default, DHCP is enabled.
5
DEF Push Button
To reset/reboot the device, press and release the button.
To reset to factory settings, press and hold the button for 30 seconds.
6
OUTPUTS 1 and 2 5-pin Terminal
Block Connector
Connect to a single balanced stereo audio output or two separate mono outputs
(+,
–, G).
7
RS-232 3-pin Terminal Block
Connector
Connect to a serial controller to control this device.
Step 3: Install FC-101NET
Install
FC-101NET
using one of the following methods:
Attach one side of the adhesive dual lock tape to the metallic surface of the device
and the other to a flat surface.
Fasten a bracket (included) on each side of the unit and attach it to a flat surface.
For more information go to
www.kramerav.com/downloads/FC-101NET
Mount the unit in a rack using an optional
RK-4PT
rack adapter.
