Using Your 7508 CV/YC to SDI Converter
5
5
5
Using Your 7508 CV/YC to SDI Converter
You can use your
7508
CV/YC to SDI Converter
to convert professional
quality composite video or s-Video (as the example in
Figure 2
illustrates)
to one or two SDI video outputs.
To convert composite video or s-Video to up to 2 SDI video outputs, do the
following
1
1. Connect a composite video source (for example, a VCR) to the CV BNC
INPUT connector.
:
2. Connect an s-Video source (for example, a camera) to the Y/C 4-pin
INPUT connector.
3. Connect both SDI outputs to SDI acceptors as follows (when only one SDI
output is required, use either of the SDI outputs of the
7508
, and leave the
other SDI output unconnected):
•
Connect the SDI OUT 1 BNC connector to an SDI acceptor
(for example, an SDI monitor)
•
Connect the SDI OUT 2 BNC connector to the second SDI
acceptor (for example, an SDI monitor)
4. Set the DIP-switches, as section
5.2
describes
5. Connect the 12V DC power adapter to the power socket and connect the
adapter to the mains electricity.
The composite video
2
or s-Video
3
6. Connect a PC (if required) to the RS-232 port (see section
signal converts to SDI at both SDI OUT
1 and SDI OUT 2.
5.1
).
1 Switch OFF the power on each device before connecting it to your 7508. After connecting your 7508, switch on its power
and then switch on the power on each device
2 To choose the CV input, set the Y/C (DIP 1) OFF
3 To choose the Y/C input, set the Y/C (DIP 1) ON
