Setup and Installation
3
4 Setup and Installation
With regard to connecting the cables:
We recommend mounting and connecting all cabling to the
Cobra TA
Video / Audio Transmitter
components before applying power.
Be sure that the CAT5 cable you intend to use has been tested to comply
with the T568B wiring specification (see Appendix A).
4.1 Making the Connections
This section contains figures showing connections with the specific
Cobra
Series models. In general, however, the connection and setup procedure at
both transmitter and receiver ends is as follows:
At the transmitter end:
1. Connect the source video to the
Cobra TA
Series transmitter video input
port, which is an HD15 connector labeled VIDEO INPUT.
2. Make your audio connections via the 1/8” (3.5mm) audio connector.
3. Connect the CAT5 cable to the transmitter.
4. Apply power on the transmitter. The LED should light.
At the receiver end (refer to the receiver user manual):
1. Connect the VIDEO OUTPUT HD15 connector to the display unit.
2. Connect a 1/8” (3.5mm) audio cable to the AUDIO OUTPUT connection.
3. Connect the CAT5 cable to the UTP connection.
4. Apply power. The LED should light and video should appear on the
display (make sure display is powered ON).
5. To adjust video levels see appropriate section in receiver user manual.