KRAMER: SIMPLE CREATIVE TECHNOLOGY
Setup and Installation
4
At the receiver end (refer to the receiver user manual):
1. Connect the VIDEO OUTPUT HD15 connector to the display unit, and
attach any audio (AUX I/O) and/or serial connections (RS-232)
depending on the model of the
Cobra
CAT 5 Video System.
2. Connect the CAT 5 cable to the LINK INPUT connection. If daisy
chaining units, connect the output CAT 5 cable to the LINK OUTPUT
connection.
3. Apply power. The LED should light and video should appear on the
display (make sure display is powered ON).
4. Adjust video levels and skew compensation per appropriate receiver
manual.
4.2 Connections on the Single-Port VGA/RS-232
The Single-Port
Cobra T2
CAT 5 Video System with RS-232 supports video
and full-modem serial (RS-232) signals over CAT 5 cable. You can also use
the transmitters and receivers to make video-only connections without serial
communications. Figure 1 shows the Single-Port
Cobra T2
CAT 5 Video
System with RS-232 Transmitter connections.
NOTE
Even though both transmitter and receiver units contain audio jacks,
audio is not supported on the RS-232 version. Plugging in audio cables
may interfere with the RS-232 serial communications.
Figure 1: Connecting the Cobra T2
NOTE
Serial communication mode is unidirectionally broadcast when using
transmitters and daisy-chained receivers. In this mode, all other devices
must be of the simplex serial type. For more information, contact Technical
Support.
