Kramer Electronics Ltd.
ASPEN-32UFX, ASPEN-1616UX, VS-8UFX
– Operating ASPEN-32UFX, ASPEN-1616UX, VS-8UFX
23
To load a saved configuration:
1. Click
Device Settings
.
The Device Settings page appears (
2. Select the relevant Preset number from the Preset 1 drop-down.
3. Click
Load
.
The input/output definitions (for
ASPEN-32UFX
and
VS-8UFX)
and switching
configuration changes according to the preset, and a message appears.
Figure 22: Preset Loaded Message
4. Click
OK
to return the web pages.
Operating
–
Front Panel Buttons
This section applies only to
VS 8UFX
.
Switching
–
Front Panel
VS 8UFX
front panel buttons enable you to switch an input to an output in the following ways:
•
– Activate a switching event immediately after pressing the buttons (see
•
– Program multiple switching events and execute them
For instructions to define whether a port is an input or output, see (see
).
Direct Switching
To switch an input to an output directly:
1. Press the required green output PORT Button
.
The selected button flashes.
If an input button is not pressed within about 10 sec, the switching operation is
cancelled, and the button goes back to its original state.
2. Press the required blue input PORT Buttons
.
The selected input is switched to the selected output and the change is reflected in the
LCD display.