Kramer Electronics Ltd.
ASPEN-32UFX, ASPEN-1616UX, VS-8UFX
– Connecting ASPEN-32UFX, ASPEN-1616UX, VS-8UFX
8
Connecting ASPEN-32UFX,
ASPEN-1616UX, VS-8UFX
Always switch off the power to each device before connecting it to your
ASPEN-32UFX,
ASPEN-1616UX, VS-8UFX
. After connecting your
ASPEN-32UFX, ASPEN-1616UX,
VS-8UFX
, connect its power and then switch on the power to each device.
Connecting ASPEN 32UFX, ASPEN 1616UX
For illustrative purposes, the figure below shows
ASPEN 32UFX
, but the same connections
apply to
ASPEN 1616UX
. The only exception is that for
ASPEN 32UFX
the sources and
acceptors can be connected to any of the 32 interchangeable ports and for
ASPEN 1616UX
the sources must be connected to the inputs and the acceptors to the outputs.
Figure 5: Connecting to the
ASPEN-32UFX
Rear Panel
To connect ASPEN 32UFX or ASPEN 1616UX as illustrated in Figure 5:
1. Connect the video sources (for example, SDI camera, FC-113 HDMI
TM
-SDI Converter)
and acceptors (for example, SDI display, VP-475UX SDI to HDMI converter):
▪
For
ASPEN-32UFX
connect up to 32 video sources and acceptors to the
interchangeable PORT BNC Connectors
.
▪
For
ASPEN 1616UX
connect up to 16 video sources to the INPUT BNC
Connectors
and up to 16 video acceptors to the OUTPUT BNC Connectors
.
2. Connect the LAN to the ETHERNET RJ-45 Connector
.
3. Connect a control device (for example, computer or serial controller) to the RS-232
Terminal Block Connector
.
4. If required, connect a genlock source to the GENLOCK BNC Connector
.