![background image](http://html1.mh-extra.com/html/kramer/21-70686010/21-70686010_user-manual_2001058023.webp)
KRAMER: SIMPLE CREATIVE TECHNOLOGY
Operating the VS-44HDxl
20
7.1.2
Switch OUT-IN Combinations in the Dual-Link Mode
To switch an input to an output in the dual-link mode, via the front panel
buttons
1
, in the AT ONCE mode (see section 7.2), do the following:
1. Press an OUTPUT button (either 1, 2 or ALL).
The selected OUTPUT button illuminates brightly, as does the 7-segment
display.
2. Press an INPUT button (either 1, 2 or OFF)
2
.
The selected input switches to the selected output, and that input button
illuminates brightly. The digits displayed in the 7-segment display change
as appropriate.
7.2 Confirming Settings
Choose to work in the AT ONCE or the CONFIRM mode (see section 7.2.1).
When the
VS-44HDxl
operates in the AT ONCE mode, pressing an
OUT-IN
combination implements the switch immediately. In the CONFIRM mode, the
TAKE button must be pressed to authorize the switch.
In the AT ONCE mode, you save time as execution is immediate and actions
require no user confirmation. However, no protection is offered against changing
an action in error.
In the CONFIRM mode:
You can key-in several actions and then confirm them by pressing the
“ TAKE” button to simultaneously activate the multiple switches
Every action requires user confirmation, protecting against erroneous
switching
Execution is delayed until the user confirms the action
Note that after ten seconds the
VS-44HDxl
will go to standby mode and the
buttons and the 7-segment display will illuminate less brightly.
7.2.1
Toggling between the AT ONCE and CONFIRM Modes
To toggle between the AT ONCE and CONFIRM modes, do the following:
1. Press the dim TAKE button to toggle from the AT ONCE mode (in which
the TAKE button is dim) to the CONFIRM mode (in which the TAKE
button illuminates).
Actions now require user confirmation and the TAKE button illuminates.
2. Press the illuminated TAKE button to toggle from the CONFIRM mode
back to the AT ONCE mode.
1 For details of how to route an input to an output using the REMOTE connector, see section 6.9
2 For immediate switching