Kraissmann 1500 S-ABS12/2Li, User Manual, Page: 8 / 16

8 |
English
Residual risks
Even if you use this electric power tool in accor -
dance with instructions, certain residual risks can -
not be rules out. The following hazards may arise
in connection with the equipment’s construction and
layout:
1. Lung damage if no suitable protective dust mask
is used.
2. Damage to hearing if no suitable ear protection is
used.
3. Health damage caused by hand-arm vibrations if
the equipment is used over a prolonged period or is
not properly guided and maintained.
BEFORE STARTING THE
EQUIPMENT
Be sure to read the following information before you put
the cordless screwdriver into operation:
▶ Charge the battery only with the charging unit sup -
plied.
▶ Only ever use sharp drill bits and screwdriver bits
which are suitable for the purpose and in faultless
condition.
▶ Always check for concealed electric cables and gas
and water pipes when drilling and screwing in walls.
OPERATION
Charging the battery
Remove the battery pack from the handle by pressing the
pushlock buttons on the left and right side of the battery
pack.
Check that your mains voltage is the same as that marked
on the rating plate. Plug the battery charger into the
power socket and connect the charging cable to the char-
ging adapter. The red LED on the charging adapter then
comes on.
Plug the battery pack into the charging adapter. The green
LED and the red LED will come on to indicate that the bat
-
tery pack is being charged.
The battery pack is fully charged after 1 hour. Remove
the battery from the charging adapter and disconnect the
charging unit from the power socket.
CAUTION!
The battery charger does not switch off automati -
cally when the battery is fully charged.
If the battery pack fails to charge, check for the follow -
ing:
▶ Voltage at the power socket
▶ Good contact at the charging contacts of the charging
unit
If the battery pack still fails to charge, send
▶ the charging unit
▶ and the battery pack to our customer service center.
To ensure that the battery pack provides long service, you
should take care to recharge it promptly. You must re
-
charge the battery pack when you notice that the power of
the cordless equipment drops. Never fully discharge the
battery pack. This will cause it to develop a defect!
Torque setting
The cordless screwdriver is fi tted with a mechanical
torque selector.
The torque for a particular screw size is set with the set
-
ting ring. The torque is dependent on a number of factors:
▶ On the type and hardness of the material involved
▶ On the type and length of the screws used
▶ On the requirements that the screw connection has to
satisfy
The grating disengagement of the coupling indicates that
the selected torque level has been reached.
CAUTION!
Only ever adjust the setting ring when the equip -
ment is at a standstill.
CAUTION!
For screwing purposes, the drill/hammer drill selector
switch must be changed to the „Drill“ setting!
Drilling
For drilling purposes, adjust the setting ring for the
torque to the last setting “Drill”. In the drill setting the
slip coupling is non-functional. The maximum torque is
available for drilling.
Changeover switch
The slide switch above the On/Off switch is for setting
the direction of rotation of the cordless screwdriver
and for preventing the cordless screwdriver from being
switched on inadvertently.