Operating Instructions
This section provides easy step by step instructions for operating your fireplace.
1. Make sure the unit is unplugged from the power source
。
2. Plug the fireplace into a 15AMP/120volt outlet. If the cord does not reach, you may use an
extension cord rated for a minimum of 1900 watts.
To access the controls, open the bottom of the fireplace at the front of the unit (see Figure A).
A. MAIN ON/OFF SWITCH
The on/off switch supplies power to all fireplace functions (heater/flame).
B. HEATER THERMOSTAT CONTROL
To adjust the temperature to your needs, turn the thermostat control completely clockwise to
turn on the heater. When the room reaches the desired temperature, turn the thermostat knob
counter clockwise until you hear a click. Leave it in this position to maintain the room
temperature at this setting. For additional heat, turn clockwise until you hear the click again and
the heater will turn on. To turn the heater off, switch the HEATER ON/OFF SWITCH to the OFF
position.
C. HEATER ON/OFF SWITCH
The HEATER ON/OFF SWITCH supplies power to the heater fan and the heater element.
NOTE:
When switched ON, the heater fan will operate. The heater element may or may not be
on, depending on the thermostat control setting (see “HEATER THERMOSTAT CONTROL”).
When the HEATER/FAN pilot light is lighting, it indicate that the heater is on.
Warning: During any service of this appliance, the power to the unit must be turned off. It
is not acceptable to use the “ON/OFF” switch to meet this requirement.
(Refer to
operating instruction section)
D. INSTRUCTIONS FOR POWER
This heater is for use on 120 volts only. The cord has a plug as shown at A in the following figure.
An adapter as shown at C is available for connecting three-blade grounding-type plugs to
two-slot receptacles. The green grounding lug extending from the adapter must be connected to
a permanent ground such as a properly grounded outlet box. The adapter should not be used if
a three-slot grounded receptacle is available. (For U.S. only)
For Canada the use of an adapter is
NOT
permitted. You must contact a qualified electrician.
5
Figure A
Summary of Contents for EF4901
