#CLW-72 R.1 April 2019
Hussong Mfg. Co., Inc. • Kozy Heat Fireplaces
FIREPLACE SETUP 41
8.0 FIREPLACE SETUP
8.1 Glass Frame Assembly
WARNING: Do not operate this fireplace with the glass removed,
cracked, or broken. Replacement of the glass assembly should be done
by a licensed or qualified service person.
8.1.1 Remove Glass Frame Assembly
WARNING: Do not remove the glass assembly when hot.
1. Remove the safety barrier.
2. Locate (4) spring-loaded latches securing the glass assembly at
the top of the firebox. Use the provided tool to unlatch the latch
assemblies from the flange on top of the glass valance.
3. Tilt the top of the glass valance forward and lift up to remove the
valance resting on the bottom frame rail.
8.1.2 Install Glass Frame Assembly
1. Tilt the top of the glass valance forward and align the glass
valance with the bottom frame rail
2. Use the provided tool to pull the (4) latch assemblies to latch
with the flange on top of the glass valance.
3. Reinstall safety barrier.
8.2 Burner/Perimeter Media Installation
WARNING: DO NOT BLOCK PILOT WITH MEDIA. A BLOCKED PILOT MAY
CAUSE DELAYED IGNITION.
8.2.1 Burner Media Kits
For media
#903-LAV, #306-COP, #306-BLK
1. Install an even layer of your chosen media across the whole
burner. See Figure 8.2.
2. Save any unused media for later use.
8.2.2 Perimeter Media Kits
For media (2) #904-LAV, (2) #301-COP, #301-BLK, (2) #105-VERM, (2)
#104-SAND-B
1. Install an even layer of media across the front and rear perimeter.
See Figure 8.2.
2. Save any unused media for later use.
BOTTOM FRAME RAIL
GLASS VALANCE ON FRAME RAIL
VALANCE AGAINST UNIT
PROVIDED LATCH TOOL ATTACHED
TO TOP LATCH ASSEMBLY
ALL FOUR LATCHES SECURING VALANCE
Figure 8.1, Glass Frame Assembly Removal
Figure 8.2, Glass Media Installation
