24
FIREPLACE SETUP
7.4 #BW20-500 Log Set Installation
CAUTION: Do not place logs directly over burner port holes.
Improper log placement may affect flame appearance and
cause excessive soot to build upon the logs and glass.
• If converting to LP (propane) gas, complete the conversion
before installing the log set. Follow the conversion
instructions included with the kit.
• Log numbers are located on the bottom of each log. Refer
to the following instructions and illustrations for proper log
placement.
1. Align the holes in the bottom of the ember panel with the
(2) mounting pins located on left and right side of the front
burner. Push to seat.
2. Align the holes in the bottom of logs BW20-1, BW20-2, and
BW20-3 with the mounting pins on the back burner. Push
logs down onto pins to seat.
3. Position logs BW20-4 and BW20-6 with the notches in base
log BW20-1 and ember panel as shown.
4. Align log BW20-5 with the notch on log BW20-1 and the
ember panel as shown.
5. Distribute rockwoll embers onto the logs and burner using a
stiff bristle brush.
Figure 7.5, Base Logs
Figure 7.6, Completed Install