44
ELECTRICAL INFORMATION
Hussong Mfg. Co., Inc. • Kozy Heat Fireplaces
#BAY-41-LE R.5 July 2019
9.3 #B41-028 Optional Fan Kit
WARNING - Electrical Grounding Instructions: This appliance is
equipped with a three-prong (grounding) plug for your protection
against shock hazard and should be plugged directly into a properly
grounded three-prong receptacle. Do not cut or remove the grounding
prong from this plug.
WARNING: Installation of this fan kit should be done by a qualified
installer. Verify household breaker is shut off prior to working on any
electrical lines.
IMPORTANT: This fan will not operate unless speed control has been
turned ON and sufficient heat has been applied to temperature control
switch. The fan will turn ON and OFF automatically as fireplace heats
and cools. Adjust fan to desired speed while it is running.
•
Hussong Manufacturing recommends to install an electrical
outlet near the fireplace.
This kit includes:
(1) Fan assembly
(2) Philips head screws (black)
(1) Temperature control switch
with magnet attached
(1) Speed control box with
cord
(4) Flange Nuts
1. Remove the safety barrier and glass frame assembly.
2. Remove log set, air deflector, and burner assembly.
3. Remove control board from firebox. See Section 8.4 Control
Board Removal and Installation on page 41 for more
information.
4. Insert fans through the opening and position on the studs at the
back of the firebox. Secure with (4) flange nuts (included).
5. Mount the speed control box onto the lower right side frame.
Align the slots in the speed control box to the holes in bracket.
Secure with (2) black philips head screws (included).
6. Place the temperature control switch (magnet attached) onto
the firebox floor on the right.
7. Plug fan cord into the speed control assembly.
8. Plug the speed control box cord into the electrical box
receptacle.
9. Reinstall all components previously removed.
10. Turn speed control counter-clockwise until it ‘clicks’. This is the
OFF position.
Turn speed control ON by turning knob clockwise past the ‘click’ -
this is the highest setting.
TEMPERATURE CONTROL SWITCH POSITION
Before adjusting temperature control switch, unplug 3-prong plug on
fan cord from receptacle.
Adjust position of temperature control switch to a warmer location
under firebox to turn fan ON sooner or move it to a cooler location
under firebox to turn fan ON later. The fan will turn on when sensor in
temperature control switch reaches 110° Fan will turn OFF when sensor
reaches 90° F.
After adjustment, plug 3-prong plug on fan cord into receptacle.
TEMPERATURE CONTROL SWITCH
GROUND
GROUND
Figure 9.3, Fan Wiring
