#BAY-36-L & BW R.8 July 2019
Hussong Mfg. Co., Inc. • Kozy Heat Fireplaces
FIREPLACE SETUP
39
8.0 FIREPLACE SETUP
8.1 Glass Frame Assembly
WARNING: Do not operate this fireplace with the glass removed,
cracked, or broken. Replacement of the glass assembly, should be done
by a licensed or qualified service person.
8.1.1 Remove Glass Frame Assembly
WARNING: Do not remove the glass assembly when hot.
1. Remove safety barrier.
2. Locate (2) spring-loaded latches securing the glass assembly at
the bottom of the firebox.
3. Pull the spring-loaded latches out and down to release the
bottom of the glass assembly.
4. Life glass assembly up and off of the (2) tabs located at the top of
the firebox.
8.1.2 Install Glass Frame Assembly
1. Align the slots on top of the glass assembly over the tabs at
the top of the firebox while lowering the bottom of the glass
assembly into position.
2. Pull the spring-loaded latches out and up to secure the bottom
of glass to the bottom of the fireplace.
3. Reinstall safety barrier.
8.2 Light Kit
ATTENTION: If converting to propane do so now before installing
light kit. Follow instructions included with the conversion kit (sold
separately).
CAUTION: Disconnect all electric power from fireplace before
performing any of these tasks.
NOTE: To avoid damage and prolong the life of halogen bulbs, never
touch with bare hands. Always use a soft cloth when handling.
1. Remove the safety barrier and glass valance.
2. Remove log set and refractory panels (if installed).
3. Remove the back log plate, burner assembly, and burner heat
shield.
4. Install halogen light bulbs into the (4) receptacles on the light kit
assembly.
5. Reinstall the burner heat shield, burner assembly, and back log
plate.
6. Place the crushed glass media (included with the fireplace) into
cavity in front of the burner.
7. Randomly place klinkers on top of glass media.
8. Reinstall the log set, glass valance, and safety barrier.
8.3 Bottom Frame Removal
and Installation
To access the control module housing, the bottom frame will need to
removed. It must be reinstalled after servicing to maintain clearances .
1. Remove the safety barrier.
2. Locate the bottom frame.
3. Lift the bottom frame up and out of slots on firebox floor.
4. To reinstall, align the tabs on the bottom frame and lower into
position.
5. Reinstall safety barrier.
Figure 8.1, Bottom Frame Removal