Getting Started
Installation and
Safety Guidelines
1–4
Getting Started
DL05/06 Option Modules, 4th Edition, 07/02
Before installing the option module in the DL05 option slot or the DL06 option slots
set the necessary jumpers and/or dip switches on the module. Refer to the
chapter(s) that pertains to the module(s) being installed.
The first step in installing the option module is to remove the protective option slot
cover. Remove the cover by squeezing the pinch tabs and lifting the cover off.
Option Module
Slot Covers
Pinch Tabs
C0
C4
C2
X1
X3
X4
X6
X11
X13 X14
X16
X21
X23 N.C.
C1
C3
X2
X5
X7
X10
X12
X15
X17
X20
X22
X0
N.C.
AC(N) 24V
0V
N.C.
C1
C3
Y0
Y15
Y12
Y10
Y17
Y7
Y5
Y2
C0
C2
Y16
Y14
Y13
Y11
Y6
Y4
Y3
Y1
LG
G
AC(L)
2.0A
OUTPUT: 6–240V
50 – 60Hz 2.0A, 6 – 27V
INPUT: 12 – 24V
3 – 15mA
Y
X
40VA
50–60Hz
PWR: 100–240V
0
1
2
3
4
5
6
7
10
11
12
13
14
15
16
17
20
21 22
23
PORT1
PORT2
TERM
RUN STOP
PWR
RUN
CPU
TX1
RX1
TX2
RX2
D0–06DR
Now, insert the module into the open slot. Locate the module so the printed
information is oriented in the same direction as the markings on the PLC. Be careful
to align the female connector on the printed circuit board of the module with the male
connector on the PLC mother board. Press the module into the slot until the front of
the module is flush with the front of the PLC. Install the remaining modules in the
DL06. Once the modules are in place the PLC is ready to be programmed.
WARNING:
Power to the PLCs must be disconnected before inserting or removing a
module. Failure to disconnect power could result in serious damage to a module, the
PLC or both.
Install the Option
Module
Remove the
Slot Cover
Insert the Module
