Kospel Optimus EPJ-3, Operating And Installation Instructions

Page: 4 / 12

4
Installation and operation instruction EPJ
All installation must be carried
out with the electricity and
water supplies cut off.
Recommendation
- connect the appliance to cold
water supplies only.
Installation - Assembly
1. Fix the tap set [19] on water sup-
ply pipe [15].
2. Undo the two screws [9] and take
the front case [27] off.
3. Drill through one of the two
1,5mm holes on the back case
[28] of the appliance with a
4,5mm drill.
4. Connect the heater to the tap
body [19] with nuts [26] with the
gasket [13] and the filter [12].
5. Mark a point for the pin [32] for
fixing the appliance through the
drilled hole.
6. Disconnect the heater from the
tap body.
7. Drill a hole of 35 depth and 6mm
diameter at the marked point.
8. Connect the tap body [19] using
nuts [26] with a gasket [13] and
the filter [12] to the heater.
9. Fix the heater on the wall (fixing
screw [30], sleeve [31], and pin
[32]).
10. Put the front case [27] on the
heater and secure with two
screws [9].
11. Allow water mains pressure get
to the tap.
12. Check for leaks by opening the
taps. Do it without the spray-
Picture 1 Viev
If there is no filter [12] the
appliance can be damaged.
1
[4] - flow regulating valve
[9] - screws for fixing the case
[12] - filter
[13] - gasket
[15] - water supply
[16] - rosette
[17] - extension
[19] - tap body
[23] - spray-head
[24] - heating on indicator
[26] - nuts
[27] - front case
[28] - back case
[29] - tap
[30] - fixing screw
[31] - sleeve
[32] - pin
Installation