308108
SYMPTOM
POSSIBLE CAUSE
SOLUTION
A fuse blows as soon as the
hob is switched on.
The hob has been wrongly
connected.
Check the electrical
connections.
The hob simply switches off.
You accidentally touched the
On/Off button or touched two
buttons at the same time.
Switch the hob back on.
The hob has stopped operating
and is beeping approximately
every 10 seconds and a is
displayed.
The control panel is
fi
lthy or
has water on it.
Clean control panel.
A series of small is
displayed.
The hob has overheated.
Let the hob cool down and then
use a lower setting.
Fault code F9
The voltage is too low
and/or the hob is not properly
connected.
Have your connection changed.
Other fault codes.
Defective generator.
Contact the service
department.
Safety instructions for the installation
• The connection must comply with national and local
regulations.
• The appliance must always be earthed.
• This appliance may only be connected by a competent
electrical installer.
• For the connection, use an approved cable in accordance with
the regulations. The cable casing should be of rubber.
• The connection cable must hang freely and is not to be fed
through a drawer.
• If you want to make a
fi
xed connection, make sure that a multi-
polar switch with a contact separation of at least 3 mm is
fi
tted
in the supply line.
• The worktop the hob is built into must be
fl
at.
• The walls and the worktop surrounding the appliance must be
heat resistant up to at least 85 °C. Even though the appliance
itself does not get hot, the heat of the hot pan could discolour
or deform the wall.
• Damage caused by incorrect connection, installation or use,
will not be covered by the guarantee.
16
Installation instructions
What you need to
consider
Summary of Contents for KIT-614-ESC
Page 23: ......
Page 24: ...SIVK6F en 12 11 ...
