Korona 20119, Instruction Manual

Page: 15 / 74

Instruction Manual
ENGLISH
15
Before First Use
• Remove all packaging material and check whether the appliance is complete and undamaged.
• Fully unwind the power cord (8) and make sure that the power cord (8) is clamped into the cable guide
(9) underneath the appliance.
• Place the appliance on an even and heat resistant surface. Do not place it on top of a metal surface.
• Connect the appliance to a properly installed wall socket and boil 4-5 kettles of water using fresh water
with each boiling cycle. Do not use this water but pour it away.
Do not use the appliance if it shows any signs of damage!
Warning: Plastic bags are a danger to toddlers and babies, therefore keep them away to avoid
suffocation.
Operation
Your appliance is fitted (inside the spout) with a scale filter that prevents scale particles ending up
in your beverage.
1. Open the lid (2) and hold the kettle (5) in an upright position to fill it with water. Make sure to fill in the MIN
amount of water (0.5L) to avoid overheating.
The kettle can also be filled with water when the lid (2) is closed by filling it through the spout (1).
2. Close the lid (2) and make sure it is properly closed.
3. Place the kettle (5) onto the base (7) and make sure it properly fits onto the contact unit.
4. Connect the appliance to the mains and switch on the water kettle by pressing the On/Off button (6).
5. As soon as the water boils, the appliance switches off automatically provided that you have thoroughly
closed the lid (2). Otherwise boiling water could spill.
6. Lift the kettle (5) off the base (7). The water is now ready for use.
You can switch off the appliance resp. stop the boiling process any time by simply pressing the
On/Off button upwards or by removing the kettle from the base.
Water left over from a previous boiling cycle can be re-used in the next boiling cycle. However, always make
sure that the water level is not too low.
Always unplug the appliance after use.
Dry-boil cut-out
Your kettle is equipped with a boil-dry cut-out, which will switch off the kettle automatically, should it
accidentally be operated without water or by not observing the minimum water level. In the event of such a
safety cut-out, switch off the appliance immediately, unplug it and let it cool down for approx. 10 minutes.
Afterwards, your kettle is ready for use again.